Rickenbacker New 4003v2 Tailpiece+Damper Assembly
The new 4003v2 Tailpiece+Damper Assembly is an updated version of the classic Rickenbacker bass tailpiece. Updates include individual saddle adjustments which allow for greater intonation, string height & functionality. Strings are threaded through the string retainer which prevents any string pull on the tailpiece itself. This assembly will retrofit all 4001, 4002, 4003, 3000 & 3001 series instruments but does require new screw holes to be drilled, these will be covered by the Tailpiece+Damper Assembly when it is installed. Directions and installation template included.
4003v2 Tailpiece+Damper Assembly installation directions.
Remove strings and loose bridge from tailpiece
Remove and save pickguard screws (10)
Unsolder bridge ground lead from wire harness
Remove bridge mounting screws from tailpiece and remove tailpiece
Place template in place of tailpiece
Use original mounting holes and screws to attach and align template in correct position
Use #41 drill bit to drill new tailpiece mounting holes using the template as your guide
Remove screws and template from instrument
Mount string retainer to instrument using screws supplied (4)
Feed ground wire through access hole to control cavity
Mount new tailpiece to instrument using supplied screws (4)
Re-solder bridge ground lead to wire harness
Re-attach pickguard with (10) screws
Feed first intonation screw through string retainer and place spring
Place proper saddle on tailpiece and attach to intonation screw
Repeat steps 14 & 15 for remaining saddles
Restring instrument and adjust the tailpiece to personal preference
